CMP Helios Stainless Steel Fire Performance Cleats for use with fire performance cables.
The Helios Standard Duty, One Bolt, High Temperature Fire Rated Stainless Steel single cable cleat is a fabricated metallic cleat which has been designed, constructed, and tested in accordance with the International Standard ‘Cable Cleats for Electrical Installations’ (IEC 61914).
These Fire Rated cable cleats can be used with fire performance cables to ensure the safe retention and securing of single cables in the event of a wiring system being affected by fire. These fire resisting supports help to maintain the electrical systems integrity for any critical circuits during an emergency situation to enable safe evacuation. The cable cleat is fabricated from Stainless Steel 316L making it suitable for both indoor and outdoor applications.
The Helios High Temperature Stainless Steel 316L cable cleat is available in eleven sizes suitable for cable diameters of 10mm up to 65mm. The cable cleat has an M10 clearance hole for securing it to a mounting surface.
Features:
- Fabricated Stainless Steel 316L
- Operating temperature -60°C to +250°C
- Surpasses requirements of Fire testing BS5839 / BS8491 / EN50200 / BS8434 / AS-NZS 3013 (1,200°C) (Fire, shock & water)
- 10 – 65mm cable range take in 11 sizes
- Single bolt fixing design
- Can be stacked
- Corrosion resistant
| Parallel Formation | |
|
One Short Circuit 600mm Fixed Cleat Centres 100mm Cable Centres |
Two Short Circuit 600mm Fixed Cleat Centres 100mm Cable Centres |
| 0.1 sec | 0.1 sec |
| 60kA Peak | 60kA Peak |
| 29kA RMS | 29kA RMS |
| BS 5839 ‘Fire detection and fire alarm systems for buildings. Code of practice for design, installation, commissioning and maintenance of systems in non-domestic premises’ States that “Methods of cable support should be non-combustible and such that circuit integrity will not be reduced below that afforded by the cable used, and should withstand a similar temperature and duration to that of the cable, while maintaining adequate support” To adhere to this BSI standard fire rated Cable Cleats must be used to support the cable in the event of a fire. |
